Cold Rolled Special Steel Strips
Carbon Tool Steels
Handsaws, Cutter Blades, Industrial Equipment
Thickness
0.10-2.0mm
Width
3.0-300mm
Length
COIL or SHEET less than 2000mm
This is the manufacturing range of coils and sheets we manufacture.
Unless otherwise specified, we manufacture in accordance with JIS standards.
[note 1]"M" at the end of JIS steel grade symbol means steel grade corresponding to JIS G3311 Cold rolled special steel strip, and M may be abbreviated in some cases.
Overseas standards are listed as equivalent or similar to our materials, so please use them as a reference.
JIS
SKS51M (G3311)
AISI/SAE
L6
The following values are typical values for high carbon steel(Fe-0.8C).
Density
7.84 g/cm³
Specific Heat
490 J/(kg・K)
Electrical Resistivity
18 μΩ・cm
Young's Modulus
208 GPa
Thermal Expansion
11.0×10-6/K(0~100℃)
Thermal Conductivity
50.2 W/(m・K)
Magnetism
Strong
Although cold rolled special steel is usually supplied in a rolled condition (as-rolled or rolled finish), we can manufacture it from the softest annealed finish to the hardest full hardened finish.
You can select the finish that best suits your needs and application.
SKS51 is a steel grade that can be quenched.
The general quenching condition is [Oil cooling at 790~850℃(Water Cooling at 760~820℃ ) ].
After holding for tens of seconds to several minutes depending on sizes, shapes, required properties, and quenching method, cooling is performed.
Water cooling is harder to quench, but due to the risk of quenching distortion and quench cracking, oil cooling may be used in some cases.
Please select tempering temperature according to required hardness and toughness by referencing quenching and tempering curve.
We manufacture carbon steel (SC material) and carbon tool steel (SK material) that conform to "JIS G 3311 Cold Rolled Special Steel Strip" and "JIS G 4802 Cold Rolled Steel Strip for Springs", as well as our own composition-adjusted steel grades for special applications.